Installation Planning Guide SuperVent 2100 Tested to 2100°F.  Listed to ULC Standard S-629M   Installations may vary, please refer to the installation instructions How to use this Planner: Before you begin, determine the Chimney diameter required. This should be the same diameter as your Wood Stove Flue Outlet 1. Select type of installation - By determining where your chimney will run. 2. Determine Total System Height - From the Connector Pipe to the top of the roof 3. Determine Roof Pitch - Refer to Roof Flashing Selection Chart 4. Determine if Chimney Offset Kit is Required   Now Follow the Steps to Complete the Material List for your Installation   STEP 1 - From the selection below; select your type of installation and the diameter of pipe required.       Cathedral Ceiling Support Planner - More Info 6" 7" 8" Decorator Ceiling Support Planner - More Info 6" 7" 8" Wall Support Planner - More Info 6" 7" 8" Cathedral Ceiling Support Installation: Ceiling Support Installation: Wall Support Installation: Cathedral Ceiling Support Kit - JM*CCSK (6" & 7" ONLY) - Deluxe Rain Cap - Support Band - Cathedral Ceiling Support - Stove Pipe Adaptor - Trim Angles Ceiling Support Kit - JM*DCSP (6" & 7" ONLY) - Deluxe Rain Cap - Attic Insulation Shield - Decorator Ceiling Support - Stove Pipe Adaptor Wall Support Kit - JM*WSP (6" & 7" ONLY) - Deluxe Rain Cap - Wall Bands (2) - Adjustable Wall Support - Stove Pipe Adaptor - Wall Thimble - Insulated Tee with Plug - Locking Band